SidePak Aerosol Monitor Training Course

Preparation step two - Remove the inlet assembly

Remove the inlet assembly

  1. Use the supplied screwdriver to loosen screws that attach the inlet assembly.
  • The screws should only be loosened. they should extend out from the inlet assembly without being fully removed (as pictured).
  • When the screws can be extended, they have been loosened enough to remove the entire inlet assembly.

  • Hold the inlet assembly and gently wiggle it until it dislodges from the SidePak unit.
Hint
You can use the supplied screwdriver to gently dislodge the assembly.
Previous Step
Back to Index
Next Step